Earlier this week I replaced two X10 modules in my Man Cave. I replaced an X10 slimline wall remote with a Z-Wave remote. As part of this replacement I also swapped out an X10 appliance module with a new GE 45603 Z-Wave Technology Wireless Lighting Control Fluorescent Light and Appliance Module. The appliance module was in the typical cost range for a Z-Wave module of about $40.

The two modules work great together and I haven’t had any problems since I installed them. I can reliably control the connected lamp for the first time since I added home automation modules to this room.

The module includes two outlets. One is for Z-Wave control and the other is a pass-through to power another non-controlled device. It includes a manual on-/off button as well. In the photo you may notice that the power outlet is installed sideways. This is another side effect of owning an older home. Typically, in a house with a power outlet aligned vertically, both outlets on the module would be perpendicular to the floor. This is intended to free up the other outlet but whether or not this actually happens will depend on the size of the power plug used by another device in the other outlet.